SL10 Maximaal limiter relay



Bestel
De knop Toevoegen aan winkelwagentje verschijnt zodra u de bovenstaande waarden selecteert
Detail

The SL10 is a single rack space Sound Pressure Level meter with special triggering circuits. When monitored sound exceeds a specified level, a relay connected to a switched output is activated. The switched output can then activate connected ancillary equipment which can be used to notify the manager, light a light, ring a bell, or activate a compressor. It can even be used to activate a counter to determine how often sound exceeds the specified level. The choice of ancillary equipment is made by the installer to accommodate the particular situation. A second relay allows the SL10 to reduce sound levels by 6dB (20%) for 5 seconds. This feature is designed to encourage performers / DJs to reduce to the specified sound level.
TriggeringCircuit:
This circuit will respond when the SL10 monitors a sound which is over the user's specified level. A switched output control relay and an audio attenuation circuit will be triggered.
Switched Output Control:
The SL10 provides a rear panel mounted terminal strip to which an installer can connect ancillary equipment suitable for the installation. This terminal strip becomes "active" when the switched output control relay is triggered. Connected equipment can range from a simple light bulb to a heavy duty solid state relay capable of handling multiple announcement devices.
Audio Attenuation Circuit:
The SL10 will accommodate two audio channels. The input and output connectors for these channels are hard wired through the unit and will not interfere with the sound quality. If connected, the audio attenuation circuit will reduce the all over sound level by 6db (20%) for a 5 second interval. If the sound level is not reduced the circuit will be repeatedly activated to reduce the sound level for 5 second intervals. The switched output control circuit and the audio attenuation circuit can be utilized simultaneously or independently.

Kenmerk
  • Response Control
  • Recovery Control
  • Reset Delay Control
  • The Controls:
    - Set: The set control is provided to specify the maximum allowable sound level
    - SPL Weight: Measurements can be made in SPL FLAT, A, or C
Specificatie
Measurement Range: Microphone input: 47dB - 123dB SPL
Inputs: Microphone: XLR 3 pin jack. Pin (1) Ground, Pin (2) Hot, Pin (3) Neutral
  Audio: RCA jacks. (2)
Outputs: Switched terminals: Fused 2 position terminal strip rated @ 1A, 125Vac
  Audio: RCA jacks (2)
Microphone: 600 ohm omnidriectional electret condenser. Model MK07. (Cable not included)
Display (SPL): 3 digit via 7 segment display
Trigger Level: 60dB - 120dB typical
Response, Recovery Times: Inter-related, varies depending on type of signal vs. control settings
Reset Delay: 10s - 120s
Monitored Source Level Reduction: 6dB (20%) for 5s
Case Material: Painted aluminum
Weighting: IEC A, C and Flat
Power: 12Vdc @ 500mA via 3.5mm jack (battery eliminator supplied)
Size: 19" x 1-3/4" x 8½"(W x H x D)
Weight: 3 lbs.
Goedkeuring: CE, RoHS en WEEE
Content
- SL10 Maximaal limiter relay
- MK07 Mini microfoon 123dB SPL
- ABF5 Certificatie calibratie SL10
- GB10 Gebruiksaanwijzing
Optie
- ABF5 Certificatie calibratie SL10
- ABF6 Voedings adapter SL10
- KG15 Instrumentkoffer maxi (157 mm)
Prijs
1.195,48 € (988,00 € excl. btw) stuk

Prijzen zijn per stuk, exclusief 21% BTW en gelden voor levering af magazijn Voorthuizen. Bij levering in Nederland of in België worden verzendkosten altijd in rekening gebracht tot maximaal EUR 25,00. Ditzelfde geldt voor expreskosten en/of rembourskosten. Bij de producten trainingen en cursussen is na het bevestigen van de cursusdatum, bij het niet verschijnen van de deelnemer(s), de verplichting ontstaan tot volledige betaling. Het volgen op een latere datum ingeval van niet verschijnen is in overleg mogelijk, maar wordt uitsluitend gezien als service. Hieruit kan geen enkel recht uit worden onttrokken.