Kortsluiting
AJW5 Sluiting lengte meter energiekabel
[super_tabs style="outline" style_color="#0000ff" animation="foldVer" show_arrows="yes" align="justify" speed="1500" deeplink="yes"][super_tab title="Detail"]
The AJW5 is a new class of tester using Spread Spectrum Time Domain Reflectometry (SSTDR) to monitor energized circuits intended to locate the distance to a circuit anomaly that is either intermittently causing a change in the circuit’s characteristics or blowing the circuit breaker. The AJW5 can capture and save up to two events (open and/ or short) per test session and save them separately. The AJW5 allows unattended monitoring of energized dedicated circuits to locate fault on the line. Connect the main unit to your circuit, press the Test button to begin monitoring and walk away. Come back later or the next day to find out the why-when-and-where’s faults are occurring on the circuit and causing the circuit breaker to trip. If the circuit breaker trips, the backup battery powers the AJW5 to allow for an orderly shutdown. The last faults can be viewed using the battery power. An In-Line Adapter is used to isolate the circuit being monitored from the breaker panel and all other breakers.
[/super_tab]
[super_tab title="Kenmerk"]
- In-line monitoring of energized dedicated circuits up to 300 VAC and 40 amps
- Allows unattended monitoring for intermittent faults
- No Splicing - Plug in with existing wiring
- Identifies intermittent opens, shorts and arc faults
- Able to detect faults that circuit breaker may not
- Runs on in-line power in monitor mode
- Fault location reported as distance from the Fault Trapper in feet/meters
- Easy-to-use three-button operation
- Backlit LCD display for dark areas
- Back-up battery allows capture of breaker trips/unpowered display of results
- 300V CAT III, 120/240Vac, 40 amps or less, single phase
[/super_tab]
[super_tab title="Specificatie"]
[table]
| Measurement method: | Spread Spectrum Time Domain Reflectometry (SSTDR) |
| Accuracy: | +/- 10% of the reading |
| Maximum Length: | 90 meter (300 ft on NM-B or Wire in Conduit) |
| Input Rating: | 90 to 265 Volts AC RMS 50/60Hz, 4 Watts max. (Main Unit) |
| 300 Volts AC RMS, 40 Amp circuits maximum supplies power to main unit (In-line 40 Amp) | |
| Rating: | 300V CAT III, 120/240Vac, 40 amps or less, single phase |
| Altitude: | 2,000 meter |
| Long Term Storage w/ battery: | 35°C |
| Humidity: | 10% tot 90% non-condensing |
| Battery use and life: | Used to view results when not AC powered |
| Battery low level: | Approximately 5.5 volts |
| Battery life typical: | 9 Volt alkaline battery |
| Standby mode (non-viewing): | 2 years |
| Active viewing mode: | 4 hours typical |
| Operating temperature: | 0 to 50°C |
| Storage temperature: | -20 to 60°C |
| Dimensions: | 15.25 x 7.6 x 3.8 cm (Main unit) |
| 11.5 x 7.6 x 5.85 cm (In-line 40 Amp) | |
| Weight: | 255 gram with batteries (main unit) |
| 312 grams (In-line 40 Amp) | |
| Goedkeuring: | CE, TüV-tested to UL 61010-1:2012, CAN/CSA-C22.2 No. 61010-1-12 |
| CE, RoHS en WEEE |
[/table]
[/super_tab]
[super_tab title="Content"]
AJW5 Sluiting lengte meter energiekabel
[/super_tab]
[super_tab title="Optie"]
[/super_tab]
[super_tab title="Prijs"]
[note style="5" icon="yes" radius="10px"]
Prijzen zijn per stuk, exclusief 21% BTW en gelden voor levering af magazijn Voorthuizen. Bij levering in Nederland of in België worden verzendkosten altijd in rekening gebracht tot maximaal EUR 25,00. Ditzelfde geldt voor expreskosten en/of rembourskosten. Bij de producten trainingen en cursussen is na het bevestigen van de cursusdatum, bij het niet verschijnen van de deelnemer(s), de verplichting ontstaan tot volledige betaling. Het volgen op een latere datum ingeval van niet verschijnen is in overleg mogelijk, maar wordt uitsluitend gezien als service. Hieruit kan geen enkel recht uit worden onttrokken.[/note]
[/super_tab][/super_tabs]
